i2c is not Detect

[allacmc]

Please help me if you can.

I bought the BM30 depth sensor.

I managed to get it to work perfectly on the Raspberry PI 3 model B v1.2

But now I have a challenge:

Make this sensor work on NanoPI NEO.

I have this need because the equipment I’m going to use needs to be extremely small and that would make the project much easier because the NanoPi NEO is very small.

But I can’t get the sensor to work.

It is not detected in the i2c protocol of NanoPI NEO.

Does anyone have any suggestions.

I’ve already tried to put the PULL-UP resistors but I’m not sure if I’m correct.

Can someone help me ?

This picture for i2cdetector

[bikingfreak]

I have the same problem using the Focal image on my Nano Pi Neo LTS 512M. i2cdetect -y 0 fails to find address 76 or 77. Has anyone else had success with I2C with any image that runs on this board?